Displaying 161-170 of 245 results for

In response to nationwide precautions due to COVID-19, CGTech is moving its North American 2020 VUE events online. Rather than delay the events, originally scheduled for April and May, CGTech will hold several online sessions for VERICUT users to attend virtually.

In the U.S., we are not seeing any specific localized disruption yet, although I’m watching New Jersey where it could be on the cusp. There are a lot of manufacturing facilities there in pharmaceuticals and chemicals, and therefore that’s an area I think we should be paying attention to.

Pivot International is a 47-year-old company. We’ve done product development and we manufacture as a service provider. We’re in a large degree of industries of technology.

One is developing and maintaining an efficient metrology strategy across the manufacturing enterprise, including hardware and software compatibility. Quality managers are asking themselves; how do we manage all our different devices and the software that runs them?

Listen to this Smart Manufacturing magazine article: Pandemic makes case for more automation, robotics. Outbreak poised to prompt changes in the way manufacturers use automation.

A whole new layer of insight can be harvested inside factories with the data you already have, today. Companies are sometimes holding back from leveraging sensors and tools like AI and deep data analysis that would allow for it because of cultural gaps between, for example, IT and OT. Ownership issues can also be a problem if some are, say, building devices vs operating devices. Paul Boris, EVP at Praemo fights against using red herrings like security concerns inside the same factory to continue down the same old paths that limit performance. He understands how seductive risk avoidance can be. And he speaks frankly about this and other issues with Brett Brune, editor in chief of Smart Manufacturing magazine.

The company expands Xcelerator portfolio to use knowledge-based approach for defining MBD

What are some new technical trends in enterprise resource planning (ERP) software?

With CAD/CAM software, machine operators and manufacturing engineers are always looking for the latest twists along the route to optimizing their metalcutting performance.

While the manufacturing industry learns to deal with COVID-19, it is also undergoing seismic change from other critical issues. Four industry leaders take on these issues in a panel discussion titled, “How Smart Manufacturing is Disrupting the Supply Chain - Are You Prepared?”