Ceratizit Wins Innovation Award for the Additive Manufacturing of Carbide Parts December 18, 2020 The Ceratizit Group has won the 2020 Innovation Award of the FEDIL business federation in the ‘Process’ category for the development of a new process for the additive manufacturing of tungsten carbide-cobalt.
Manufacturers May Turn to Digital to Recover From Pandemic December 9, 2020 Manufacturers may look to investing in digital technology as they seek to recover from the COVID-19 pandemic, consulting firm Deloitte said this week in a report.
Manufacturing Adds 27,000 Jobs, Led by Motor Vehicles December 4, 2020 U.S. manufacturing added 27,000 jobs last month, buoyed by gains in motor vehicles and parts, the Labor Department said today.
Shrink-Fit Technology Enhances Shop’s ROI November 25, 2020 Raym-Co Inc., located in Farmington, Conn., is a job shop with a 37,000 ft2 (3,065 m2) facility and approximately 60 CNC machines.
EMO 2021 Scheduled for October 2021 in Milan, Italy September 24, 2020 Betting that the worst of the pandemic will be over and travel restrictions lifted, the 2021 edition the machine tool exhibition is putting out the welcome mat to the world.
Kennametal Introduces Flat Bottom Geometry for KenTIP FS September 9, 2020 New replaceable drill tip saves tooling costs and eliminates process steps
Auto Industry Gets Back Into Gear Following COVID-19 Shutdown August 17, 2020 The North American auto industry slammed on the brakes in March because of the novel coronavirus (COVID-19). The sector already had been forecast to slow down in 2020, with lower light-vehicle demand. That turned into a sudden stop as the coronavirus spread.
Machine Tool Processes Depend on Creative Enablers July 30, 2020 It is fair to say that IMTS, virtual or otherwise, presents the ultimate manufacturing tool box, where shops can find the newest, most innovative and proven devices for holding, moving, cutting, bending and inspecting workpieces.
Recycle, Reclaim, and Take a Deep Breath July 2, 2020 Suppliers of cleaning, safety, and environmental equipment are promoting a common message—good housekeeping is not only good for your workforce, it’s also good for the shop’s balance sheet.
Practical Holemaking Automation In CAM Software May 26, 2020 Holemaking. A layperson might think, “what could be simpler?” But a machinist knows better because there’s a lot to consider when creating a streamlined toolpath.