Displaying 81-90 of 488 results for

The challenges to manufacturing as it evolves into the 21st century are now familiar, and impact how metrology must contribute. Manufacturers face uncertain production volumes with roller-coaster demand, shorter production runs and faster product development cycles. Automation, while alluring as a way to reduce cost, needs to adjust.

Today’s products require high finishes, burr-free edges, freedom from contamination, and often close tolerances. Electropolishing provides all of those conditions and more in a matter of seconds for many metal parts. It is a process that has been used for more than a hundred years. It is widely known and the science is widely discussed, but its ability to run job shop lots and high-precision high-volume parts in the same equipment makes it a bit unique.

It is reported that, not too long ago, before the current precipitous decline in machine-tool shipments, the number of 30-taper machines that were being manufactured and sold in Japan had surpassed the numbers of 40-taper and 50-taper machining centers.

To remain competitive in the fiercely contested North American automotive industry, the New United Motor Manufacturing Inc. (NUMMI, Fremont, CA) assembly plant, a joint venture between Toyota Motor Corp. (Aichi Prefecture, Japan) and General Motors Corp. (Detroit), has rededicated its efforts in lean manufacturing during the past few years by applying key tenets of the Toyota Production System (TPS). 

Because it is a production cost, reducing the need for deburring can help the bottom line. In this podcast, part two of two, Alan Rooks, Editor in Chief of Manufacturing Engineering magazine, talks with Dr. LaRoux Gillespie, a researcher, engineer, manager, consultant, and writer with an extensive knowledge base on deburring and finishing. In this episode, the discussion focuses on ways to reduce deburring costs in forming and fabrication operations, such as improving product design; preventing burrs; minimizing burr properties; and removing burrs during the main fab process. Also discussed are how shops can determine if deburring or edge finishing is needed, and how they can choose among the 124 different deburring processes.

In a few short years, the Center for Manufacturing and Metrology at the University of Hartford has become a leading national provider of education, training and research in measuring technology for manufacturing.

In 2021, Mastercam is partnering with Edge Factor to equip organizations across North America

SME, the professional association committed to advancing manufacturing and developing a skilled workforce, today announced that Robert “Bob“ Willig has been named as its executive director and CEO. His employment with SME will commence on Jan. 1.

Manufacturing’s economic expansion eased in November, the Institute for Supply Management said today.

In March 2020, the World Health Organization (WHO) officially declared the novel coronavirus (COVID-19) outbreak a pandemic. Manufacturers are dealing with the fact that the virus has exposed the fact that many domestic (North American-based) brands rely significantly upon China for fulfilling some, part, or nearly all, of their supply chain.