Skip to content

Deburring in Forming and Fabricating: Part 1

Alan Rooks
By Alan Rooks Editor in Chief, Manufacturing Engineering

Deburring can sometimes be overlooked in production planning, but it is a critical part of forming and fabricating processes. In this podcast, part one of two, Alan Rooks, Editor in Chief of Manufacturing Engineering magazine, talks with Dr. LaRoux Gillespie, a researcher, engineer, manager, consultant, and writer with an extensive knowledge base on deburring and finishing gained from decades of both hands-on manufacturing and academic work. Dr. Gillespie is also a past president of SME. In this episode, the discussion focuses on key issues that create burrs in casting/forging/ molding, blanking and bending operations, and the basics of deburring in three key areas: burr properties, acceptable deburring, and cost effective deburring.

  • VIEW ALL ARTICLES
  • Connect With Us
    TwitterFacebookLinkedInYouTube