thumbnail group

Connect With Us:

Advanced Manufacturing Media eNewsletters

ME Channels / Product Previews
Share this

New ISO Inserts from Walter

Walter has introduced Tigertec Silver ISO K inserts, designed to boost performance and reliability in the machining of grey cast iron, ductile iron, and higher strength steel alloys under difficult conditions.

These inserts achieve dramatic performance increases due to the new aluminum oxide coating with an optimized microstructure that delivers improved crater wear and heat resistance. They also permit reduced machining time by enabling higher cutting parameters, and are suitable for wet or dry machining.  Walter WAL-168

The Tiger•tec Silver ISO K has an MK5 geometry that features an open chip groove for reduced cutting forces and low cutting temperatures, a strong zero degree land plus a ground seating surface, all combining to further boost reliability and process security even with dynamic loads. Tigertec Silver ISO K comes in two grades, WKK10S and WKK20S.


Walter
Ph: 800-945-5554
Web site: www.walter-tools.com/us
(W:\Pub\ME\2013 ME\August 2013\Product Previews\WalterWAL-168)
 


Published Date : 7/11/2013

Advanced Manufacturing Media - SME
U.S. Office  |  One SME Drive, Dearborn, MI 48128  |  Customer Care: 800.733.4763  |  313.425.3000
Canadian Office  |  7100 Woodbine Avenue, Suite 312, Markham, ON, L3R 5J2  888.322.7333
Tooling U  |   3615 Superior Avenue East, Building 44, 6th Floor, Cleveland, OH 44114  |  866.706.8665