thumbnail group

Connect With Us:

Advanced Manufacturing Media eNewsletters

ME Channels / Product Previews
Share this

FABTECH 2012: MIG Gun Liner System

Quick Load Liner AutoLength System minimizes the problems and costs commonly associated with a MIG gun liner being cut too short, including poor wire feeding, burnbacks, and premature contact tip failure. It can be used with both semiautomatic and robotic MIG guns. Housed inside the power pin, a spring-loaded module applies constant pressure on the liner, keeping it seated properly in the retaining head (or diffuser) at all times. The new system allows for up to 1" (25.4 mm) forgiveness if the liner is cut too short, and accommodates liner movement during welding. Once the AutoLength Pin has been installed at the rear of the gun, a Quick Load Liner can be installed from the front of the gun in less than half the time and effort to replace a conventional liner.

Tregaskiss Products

Ph: 877-737-3111

Web site: www.tregaskiss.com

 


Published Date : 10/19/2012

Advanced Manufacturing Media - SME
U.S. Office  |  One SME Drive, Dearborn, MI 48128  |  Customer Care: 800.733.4763  |  313.425.3000
Canadian Office  |  7100 Woodbine Avenue, Suite 312, Markham, ON, L3R 5J2  888.322.7333
Tooling U  |   3615 Superior Avenue East, Building 44, 6th Floor, Cleveland, OH 44114  |  866.706.8665