FABTECH 2012: MIG Gun Liner System
Quick Load Liner AutoLength System minimizes the problems and costs commonly associated with a MIG gun liner being cut too short, including poor wire feeding, burnbacks, and premature contact tip failure. It can be used with both semiautomatic and robotic MIG guns. Housed inside the power pin, a spring-loaded module applies constant pressure on the liner, keeping it seated properly in the retaining head (or diffuser) at all times. The new system allows for up to 1" (25.4 mm) forgiveness if the liner is cut too short, and accommodates liner movement during welding. Once the AutoLength Pin has been installed at the rear of the gun, a Quick Load Liner can be installed from the front of the gun in less than half the time and effort to replace a conventional liner.
Web site: www.tregaskiss.com
Published Date : 10/19/2012